USB to TTL Router Set-top Box Upgrade USB to Serial Download Cable Four Brush Line for Raspberry Pi



Shipping calculated at checkout


The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port., however, this cable is not good for Arduino re-programing such as a Boarduino, MENTA, Monochron, etc. because it does not have the DTR/RTS wire necessary for initiating the bootloader reboot sequence. For that we suggest an FTDI cable or FTDI friend.
Typical Application:
  MCU and PC communication (software using the UART protocol, hardware-based USB interface)
  Upgrade firmware programs, such as hard disk, satellite receiver, router and other devices using the serial port to download the program.
  Serial communication, and all TTL serial communication device communication.
  Download SCM program, such as STC microcontroller.
  Download ARM programs, such as STM32 embedded chip program.

Payment & Security


Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.

Estimate shipping

You may also like

Recently viewed